This can be turned up to 100% later but a low setting will help prevent something breaking when you are initially getting it all to work. X-Plane profile - set Extra 1,2,3 in the middle of the slide bar and Main Level to 0%. So ensure that you power on the Sabertooth first, then the Arduino Uno Note: the autobaud command that the Arduino sends to the Sabertooth may be lost if the Arduino is started before the Sabertooth. Then set that Arduino up with the settings you established are best for you. If you have more than two axis you will need to change the SMCUtils ini file for it to talk to another port. Once you are happy with the settings, click on ->M2 to copy them to the other motor. The goal is to get the actuator moving to the new position as fast and as smooth as possible. If it is jerky while trying to get to the new position, try and reduce Kp, this will smooth things out but make the actuator less responsive. The higher the PWMmax value the harder the motor will work to try and reach the new position you set by the blue dot. Gradually increase PWMmax and watch how the actuator tries to follow your manual input. If it doesn't, reverse the 0V and 5V wires on the feedback pot and try again. Drag the blue slider up a bit and see if the actuator begins moving up to meet it. Click on ->M2 to copy the settings for the second motor.Ĭlick on the radio button for Manual mode. Note: some variations of clone Unos have been reported to not work with SMC3. Step 2: Setting up the Arduino with SMC3.ĭownload the SMC3 sketch with soft start.Įdit the code at the top of the sketch to select the MODE you will be using Stick with the data outputs above only.įor the time being, that's all you need so you can close X-Plane. Untick these as it seems to make the game engine crash if they are all ticked. NOTE: After you patch the game you may need to relaunch and check the dataoutput settings in X-Plane 11 ,as it added many more data points no.s 0,1,2,13,14,15 etc when I patched it. Set the UDP rate to maximum (99.9 packets/sec) Now that you have the screen with all the checkboxes, check the following items in the last column "Network via UDP"Ĭheck the box, 'Send network data output' and enter IP Address 127.0.0.1 and Port 4123. To get SimTools talking with X-Plane, start XP and Click on Settings > Data Output Step 1: Getting SimTools to talk to X-Plane To install the plugin use the "SimTools_PluginUpdater" located in the root Simtools installation directory Using the SimTools Manager apply the patch to XP11. Even though it is quite old now, it still works with the latest version of XP11 When it asks if you want to start SimTools with Windows click Yes to both the Manager and the Engine.ĭownload the game plugin for X-Plane. Thanks to and for their contributions thus far.ĭownload SimTools and apply for or purchase the license.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |